Stow RCC130H manual Danger, Assembly Instructions/Operations

ASSEMBLY INSTRUCTIONS/OPERATIONS

FIGURE 33

DANGER

IMPROPER SAWING PROCEDURES FOR ANY

SPECIFIC RANDOM CRACK CAN

SUBSTANTIALLY REDUCE OPERATOR CONTROL, OVERALL PRODUCTIVITY AND CAUSE SEVERE DIAMOND BLADE DAMAGE, RESULTING IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.

15)Increased productivity rates can usually be achieved in intricate random crack patterns with the use of a wider diamond blade. FIGURE 34.

FIGURE 34

16)Normal usage of the Crack Saw will allow the build-up and accumulation of work surface materials on interior surfaces. It is highly recommended that both the interior and exterior surfaces be properly cleaned after the completion of each usage.

CAUTION

Failure to properly clean the interior surfaces of the Crack Saw can result in dried material build- up and accumulation directly affecting bearing and V-Belt service life.

DANGER

EXERCISE EXTREME CAUTION WHEN UTILIZING ANY SOLVENT TO REMOVE ACCUMULATED MATERIALS FROM THE SURFACES OF THE MACHINE AND RELATED COMPONENTS. MANY SOLVENTS ARE FLAMMABLE. DO NOT SMOKE OR INTRODUCE FLAME IN THE WORK AREA. PROVIDE ADEQUATE VENTILATION AND WEAR PROPER SAFETY APPAREL.

DANGER

PROPERLY DISPOSE OF ALL ACCUMULATED MATERIALS PER OSHA AND ENVIRONMENTAL

PROTECTION AGENCY CODES AND

REGULATIONS. MANY ACCUMULATED MATERIALS CAN BE CLASSIFIED AS HAZARDOUS AND REQUIRE PROPER DISPOSAL PROCEDURES. CONTACT THE APPLICABLE GOVERNMENT AND/OR PRIVATE AGENCIES FOR SPECIFIC INFORMATION.

17)On job applications where the work process creates a considerable amount of loose material, it can become almost impossible to determine proper cutting direction for the blade and the extent of work already accomplished. The problem can be compounded if a vacuum system is not utilized. Loose material should be removed by sweeping or other, appropriate processes and the Crack Saw utilized until conditions again warrant removing the accumulated material.

RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 28