Stow RCC130H manual Danger, Maintenance/Service

MAINTENANCE/SERVICE

FIGURE 35

5)Belt alignment is checked with the straightedge. Place the straightedge squarely against the arbor shaft pulley. Properly aligned pulleys should also place the straightedge squarely against the engine/motor pulley. Remove the straightedge and rotate the engine/motor pulley 120 degrees. Recheck alignment with the straightedge. Repeat the process until the engine/motor pulley is rotated a full 360 degrees. Maximum allowable misalignment is + - 1/32 inch. If pulley alignment is not within specifications, refer to INSTALLING A REPLACEMENT V-BELT for specific information. FIGURE 36.

FIGURE 36

6)Reinstall the belt guard to the main frame. Determine that all safety related decals affixed to the belt guard are fully readable. If any decal is not fully readable, replace with a factory approved, replacement part only.

7)Reconnect the engine spark plug wire. Position.

DANGER

UNEXPECTED MACHINE START UP CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.

INSTALLING A REPLACEMENT V-BELT OR PULLEY.

Tools Required:

2 each, 9/16 wrenches.

1 each, 5/32 Allen wrench.

1 each, 16 inch minimum length straightedge.

1 each, 10 lbs minimum capacity, tension scale or belt tension tool.

Parts Required:

2 each, PN BX34 V-belt (if required).

1 each, PN CS8-0260 pulley assembly (if required). 1 each, PN CS8-0270 pulley assembly (if required).

1)Position the Crack Saw on a suitable work surface with the V-belts approximately at waist level.

2)If the Crack Saw is powered by an engine, disconnect the spark plug wire. If powered by an electric motor, disconnect the extension cord or Crack Saw from the power source. If the Crack Saw is powered with a Propane converted engine, the Propane cylinder must be removed from the main frame to better facilitate the maintenance process. Determine that the Propane cylinder valve is fully closed before uncoupling the hose. Secure in a proper storage area. Using the 9/16 inch wrenches, remove the belt guard from the main frame. Clean the inside of the belt guard with an appropriate solvent. Check for signs of wear and damage. Secure in a proper storage area.

RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 32