Stow RCC130H manual Maintenance/Service

MAINTENANCE/SERVICE

FIGURE 44.

FIGURE 45

11)Clean the bearing journal areas of the arbor shaft with an appropriate solvent. Apply a suitable amount of anaerobic adhesive/sealant to the bearing journal area located near the snap ring groove. Press the arbor shaft into the replacement bearing until it seats itself against the inner race. FIGURE 45.

12)Clean the inside and outside bore of the second replacement bearing with an appropriate solvent. Apply a suitable amount of anaerobic adhesive/sealant to the inside and outside bore. Install the replacement bearing over the arbor shaft. Determine that both the inside and outside bores of the bearing will absorb the thrust from the pressing process. Press the replacement bearing into the bearing housing until it seats itself against the flange. This procedure will minimize the potential for improper bearing preloading. FIGURE 46.

FIGURE 46

13)Reinstall the snap ring into the snap ring groove on the arbor shaft.

RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 36