Stow RCC130H manual Maintenance/Service

MAINTENANCE/SERVICE

FIGURE 40

FIGURE 41

CAUTION

Exercise extreme caution when pressing the hub body from the arbor shaft/bearing block assembly. Improper activities can result in the components striking body parts, resulting in property damage and/or personal injury.

8)Position the arbor shaft assembly in a suitable arbor press with the snap ring shoulder facing down. Determine that the bearing block face is properly supported. The outside diameter of the bearing must be clear for axial movement. Press the arbor shaft assembly from the bearing block. FIGURE 42. Reposition the assembly and press the remaining bearing from the bearing block. FIGURE 43.

FIGURE 42

FIGURE 43

9)Clean and inspect the arbor shaft and bearing block for wear and damage. Replace any questionable component with a factory replacement part only.

10)Clean the outside bore diameter of the replacement bearing with an appropriate solvent. Apply a suitable amount of anaerobic adhesive/sealant to the outside diameter of the bearing. Determine that the outside diameter of the bearing will absorb the thrust from the pressing process. The inside bore of the bearing should not receive any direct thrust force. Press the replacement bearing into the bearing block until it seats itself against the flange.

RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 35