Studer Innotec XPC 1400-12 Display and control parameters on remote control panel optional

STUDER Innotec XP-COMPACT

4.2Display and control parameters on remote control panel (optional)

INVERTER - CHARGER				COMPACT
1		TRANSFER	8		A	%
AC IN				AC OUT	100	160
	2	7	9		90	160
CHARGER				INVERTER	80	130
				RESET	70	100
SOLAR CHARGE					60	80
			20	ALARM
3
				(Select)	50	60
EQUALIZE	14		10	Over Temp.	40	40
					30	20
4 Program		15	11	Overload	20	10
			12	Battery	10	5
5 Contact active		16		Low/High	Charger	Inverter
6 Contact manual		17	13	OFF
		18		ON/OFF		25
AUXILIARY CONTACT
(Program)				(Change status)
21			19

RCC-01

4.3Light Emitting Diodes (LED)

LED	Marking	LED lit	LED blinks
1	AC IN	Voltage at the AC IN input is within	Voltage, outside of the self-
		the accepted range (voltage and	adjusted values is at the AC IN
		frequency)	input.
2*	CHARGER	Battery Charger is working	The input voltage is out value
			(voltage or frequency)
3	SOLAR	Connected Solar modules are
	CHARGE	delivering energy
4*	Program	Program mode for Aux. Contact
5*	Contact active	Auxiliary Contact is activated
6*	Contact manual	Aux. Cont. manually activated
7		Transfer system is active. Input	Transfer system (by-pass) is dis-
		AC voltage is directly connected to	abled (see chap.6.5.1)
		AC OUT outlet
8	AC OUT	Voltage is present at the AC OUT	The Inverter is in Standby mode.
		outlet	No loads are detected at the out-
			put
9*	INVERTER	Inverter is working	Inverter mode is disabled (see
			chap.6.5.1)
10*	Over Temp.	For the time being the XP-
		COMPACT is out of service be-
		cause of overheating.
11*	Overload	The XP-COMPACT is out of ser-	Overload due to connection of the
		vice because of overload or short-	grid or the generator at the output
		circuit	of the inverter. Please Check the
User manual		XP-COMPACT V5.1 E	11