InternalSCSI and Storage Devices 8-7
8
6. To install a tape drive for the first time, you must firstremove the filler
mechanism:
a. Remove the filler panel from the device enclosure by loosening and
removing 4 screws.
b. Use the same 4 screws to secure the device to the device enclosure, two
screws on each side.
7. Set the replacement device SCSI ID address to 6 for a CD-ROM drive and
to 5 for a tape drive.
8. To complete installation of a CD-ROM or tape drive, reverse Step 1
through Step 4.
8.1.3 Removing/Replacing a Tape or CD-ROM Drive in anEnterprise 4000 System
Toremove and replace an existing device, perform steps 1 through 5. To install
a tape drive for the first time, proceed to step 6.
Note – For cooling purposes, the tape drive must be installed on the side
nearest the keyswitch.
1. Unlock and remove the front panel bezel.
a. To unlock the bezel, apply inward pressure on the serrated edges at the
lower left and right sides.
b. Tilt the bezel up 45 degrees to remove it.
See Figure 8-6.