3-16 UltraEnterprise 6000/5000/4000 Systems Manual—November 1996
3
2. Use a 3/32 Hex driver to loosen all screws on each of the compression
connectors on the module to be removed (three screws for the 288 pin
connector, two screws for the 144 pin connector).
See Figure 3-9.
3. Lift the module straight up, off the board mating surface and the single
standoff that locks the module to the board.
Use pressure applied with fingers to assist in removingmodule from
standoff. See Figure3-11.
Figure3-11 UltraSPARCModule Removal and Replacement
4. Place the module in an antistatic bag.
Standoff,
1 per module