the System Controller next time the switch boots. The command to change the DHCP client identifier will be removed from the next release of the switch firmware.
■4795640: Resetting with the factory default configuration causes provisioning errors
Saving a copy of the switch’s factory default configuration file (or saving a modified copy of this file) generates errors if the switch is then rebooted with the saved copy specified as the startup configuration file.You will only see these errors if you press p when asked if you want to view details of the startup provisioning. The errors can be ignored.
■4773404: No traffic statistics available for the NETMGT port
There is a known problem with the command for viewing traffic statistics. The output for the NETMGT port when you run the show interfaces counters ethernet NETMGT command (from the console# prompt) contains zeroes instead of valid data. There is currently no workaround for this problem.
■4773404: No MAC address table available for the NETMGT port
(This issue has the same Sun number as the previous issue.) There is a problem with the command for displaying the MAC address table for the NETMGT port. The show
■4789838: LACP sometimes fails if GVRP is enabled
There is a known problem with the operation of the link aggregation control protocol and the dynamic VLAN configuration protocol GVRP. It is not possible for the LACP protocol to operate reliably if GVRP is enabled. Therefore, if you are using GVRP do not enable LACP. Firmware that fixes this problem is now available from http://sunsolve.sun.com (patch number:
