Sunbeam 250-22 instruction manual Important Safeguards, Read And Keep All Instructions

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following:

READ AND KEEP ALL INSTRUCTIONS.

1.To protect against risk of electrical shock, do not put Blender base in water or other liquid.

2.Close supervision is necessary when any appliance is used by or near children, or incapacitated persons.

3.Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning.

4.Avoid contact with moving parts.

5.DO NOT operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest Authorized Sunbeam Appliance Service Center for examination, repair or electrical or mechanical adjustment.

6.The use of attachments, including canning and/or ordinary jars and processing assembly parts not recommended by Sunbeam® or Oster®, may cause a risk of injury to persons.

7.Keep hands and utensils out of jar while blending to prevent the possibility of severe injury to persons and/or damage to the Blender. If scraping, folding, etc., is necessary, turn off and unplug the Blender, and only use a rubber spatula.

8.Blades are sharp. Handle carefully.

9.To reduce risk of injury to persons, never place cutting blades on base without Blender jar properly attached.

10.Screw on jar bottom firmly. Injury can result if moving blades become exposed.

11.Always operate Blender with cover in place.

12.Make sure that the voltage in your outlet is the same as the voltage indicated on the appliance.

13.Always hold jar while processing. If the jar should turn when the motor is switched “On,” switch “Off” immediately and tighten Blender jar in threaded jar bottom.

14.When blending hot liquids, remove the feeder cap from the two‑piece cover. DO NOT fill Blender jar beyond the four‑cup level. On six-cup models, DO NOT fill beyond five-­cup level. Always begin processing at the lowest speed setting. Keep hands and other exposed skin away from the cover opening to prevent possible burns.

15.DO NOT use outdoors.

16.DO NOT let the cord hang over edge of table or countertop.

17.DO NOT let cord rest against hot surfaces.

18.DO NOT leave Blender unattended while it is operating.

E N G L I S H - 1