v i i . o p e r at i n g i n s t r u c t i o n s
Figure 10
D.REAR WHEEL REMOVAL AND INSTALLATION
The rear wheels may be removed to reduce the mobility base storage size.
1.To remove, depress the axle release button in the center of the rear wheel and pull the whole wheel and axle out of the axle tube.
(See Fig. 12)
2.To reinstall, align the axle with the axle tube end and depress the button to reinstall. Push axle and wheel assembly inward until it can go no further. When the wheel is properly installed and the axle release button will pop out.
Figure 12
!WARNING
Pull on the wheel assembly to verify that it is locked in place. Occasionally, the wheels do not both snap into place. If this should happen, then swap the wheels to opposite sides.
21
mkt3048 9921700000 Rev C
