v i i . o p e r at i n g i n s t r u c t i o n s
Lengthening the Footbed for Maximum Lower Leg Length Adjustment
The foot bed is designed so that the brackets on the ends of the telescoping tubes can be reversed to add approximately 3 1/2" of leg length adjustment.
1.Remove the footbed from the telescoping tubes by unscrewing the four button head screws on the inside of the footbed.
2.Remove the screw from each bracket by backing it out far enough to allow the bracket to slip off the end of the tube.
3.Flip the bracket over and replace it on the end of the tube being careful to allign the screw with the same hole in the end of the tube. Tighten the mounting screw so it goes through the hole and tightens up against the bracket.
4.Replace the footbed onto the brackets assuring the same angle adjustment is achieved.
U.PELVIC POSITIONING BELT LENGTH ADJUSTMENT
1.Remove any belt twists and place the belts outside of the seating area.
2.Engage wheel locks, seat the child, and snap the pelvic positioning belt ends together.
3.Adjust belt length to provide a snug fit. The adjuster is to the child's left.
Positioning Belt
30
9921700000 Rev C mkt3048
