v i i . o p e r at i n g i n s t r u c t i o n s
DD.KNEE ABDUCTOR BLOCK ADJUSTMENT (optional)
1.Identify abductor block adjustment screw location under the lead edge of the seat. There is only one abductor block adjustment screw. (See Fig. 36)
2.Loosen the adjustment screw.
3.Move the abductor block to the proper position and re- tighten the screw.
4.To remove the knee abductor, depress the button and lift the block out of the mounting bracket.
Figure 36
EE.tray support ADJUSTMENT
1.Loosen two tray support adjustment hex screws on side of seat base.
2.Adjust tray support to proper position and tighten screws.
(See Fig. 37)
3.Repeat procedure for opposite side armrest.
Figure 37
FF.TRAY INSTALLATION AND ADJUSTMENT(optional)
1.Slide the tray over the tray supports, adjust depth and clamp it in place.
2.Adjust tray supports to get proper tray height and angle. (See Fig. 38)
Note: The tray will not work if tray support heights and angles are too different from one another. Try loosening both tray supports if tray will not align properly.
Figure 38
38
9921700000 Rev C mkt3048
