SUPER MICRO Computer AS1011M-T2 user manual Support, Side and Top Views of DDR Installation

AS1011M-T2 User's Manual

Support

The H8SMi-2 supports single or dual-channel, DDR2-800/667/533 unbuffered ECC/non-ECC SDRAM.

Both interleaved and non-interleaved memory are supported, so you may populate any number of DIMM slots (see note on previous page).

Populating two adjacent slots at a time with memory modules of the same size and type will result in interleaved (128-bit) memory, which is faster than non-interleaved (64-bit) memory. The best practice is to install DIMMS in order from 1A to 2B.

Maximum memory: 8 GB of DDR2-800/667/533 unbuffered ECC/non-ECC

SDRAM.

Figure 5-4. Side and Top Views of DDR Installation

To Install:

Insert module vertically and press down until it snaps into place. The release tabs should close - if they do not you should close them yourself.

Notch

Release

Tab

Note: Notch should align with its receptive point on the slot

Notch

Release

Tab

Note the notch in the slot and on the bottom of the DIMM.

These prevent the DIMM from being installed incorrectly.

To Remove:

Use your thumbs to gently push each re- lease tab outward to release the DIMM from the slot.

5-8