Serial ATA Backplane
The Serial ATA drives plug into a backplane that provides power, drive ID and bus termination. A RAID controller can be used with the backplane to provide data security. The operating system you use must have RAID support to enable the hot- swap capability of the Serial ATA drives. The backplane has the following jumpers you need to be aware of:
JP18: Alarm Reset (high temperature alarm)
JP25: Hard drive threshold temperature (when exceeded, alarm will sound) Settings: Open = 45º C, Pins
CD-ROM and Floppy Drive Installation
The top cover of the chassis must be opened to gain full access to both drives. The
First, grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click"). Next, depress the two buttons on the top of the chassis to release the top cover and at the same time, push the cover away from you until it stops. You can then lift the top cover from the chassis to gain full access to the inside of the server.
To install either type of drive, start by disconnecting the drives' power and data cables then remove the two screws from either side of the bracket the secures the drives to the chassis. With these screws removed, you can then lift out the entire assembly (drives and bracket). Both the
Drives mount on rails and should "click" into place to be correctly and fully installed in their bays.
• A red mark on a wire typically designates the location of pin 1.
