SUPER MICRO Computer AS1011M-T2 Power LED/Speaker, Overheat LED, Chassis Intrusion, Wake-On-LAN

AS1011M-T2 User's Manual

Power LED/Speaker

On JD1, pins 1, 2, and 3 are for the power LED and pins 4 through 7 are for the speaker. See the tables on the right for pin defi nitions.

Note: The speaker connector pins are for use with an external speaker. If you wish to use the onboard speaker, you should close pins 6 and 7 with a jumper.

Overheat LED

Connect an LED to the JOH1 header to provide warning of chassis over- heating. See the table on the right for pin defi nitions.

Chassis Intrusion

A Chassis Intrusion header is located at JL1. Attach the appropriate cable to inform you of a chassis intrusion.

Wake-On-LAN

The Wake-On-LAN header is des- ignated WOL. See the table on the right for pin defi nitions. You must have a LAN card with a Wake-On-LAN connector and cable to use the Wake- On-LAN feature.

Note: Wake-On-LAN from S3, S4, S5 are supported by LAN1. LAN2 sup- ports Wake-On-LAN from S1 only.

PWR LED Connector Pin Definitions (JD1)

Pin# Defi nition

1+Vcc

2Control

3Control

Speaker Connector Pin Definitions (JD1)

Pin# Defi nition

4Red wire, +5V

5 No connection

6Buzzer signal

7 Speaker data

Overheat LED

Pin Definitions (JOH1)

Pin# Defi nition

13.3V

2OH Active

Chassis Intrusion

Pin Definitions (JL1)

Pin# Defi nition

1Battery voltage

2 Intrusion signal

Wake-On-LAN

Pin Definitions (WOL)

Pin# Defi nition

1+5V Standby

2Ground

3Wake-up

5-16