![](/images/new-backgrounds/1188807/18880739x1.webp)
2-4 Installing the System into a Rack
This section provides information on installing the server into a rack unit with the rack rails provided. If the server has already been mounted into a rack, you can skip ahead to Sections
Identifying the Sections of the Rails
You should have received a rack mounting kit with the
Installing the Rack Rails
Begin by joining one set of rack rails corresponding to either the left or the right side of the rack. Do this by aligning the studs of one rail with the holes of the other rail. Push the studs into the grooved holes and then push the rail to slide the studs to the end of the groove. Repeat this with the rack rails used for the other side.
Next, determine where you want to place the server in the rack. (See Rack and Server Precautions in Section
Locking Tabs: Both of the two chassis rails on each side have a locking tab (four total), which serves two functions. The fi rst is to lock the server into place when installed and pushed fully into the rack, which is its normal operating position.
Secondly, these tabs also lock the server in place when extended from the rack. This prevents the server from coming completely out of the rack when you pull it out for servicing. The two sets of locking tabs mean there are two locked positions when the chassis is extended from the rack, allowing easy access when servicing the system. Note that on one side, you push the locking tab up to release it and on the other side you push it down to release.