SERIES3800/S120T (7045A-C3/7045A-CT) User's Manual

CD Header

A4-pin CD header (CD1) and a Front Panel Audio header (JC2) are included on the serverboard. These headers allow you to use the on- board sound for audio CD playback. Connect an audio cable from your CD drive to the CD header that fits your cable's connector. Only one CD header can be used at any time.

Front Panel Audio Control

When front panel headphones are plugged in, the back panel audio out- put is disabled. This is done through the FP Audio header (JC2). If the front panel interface card is not connected to the front panel audio header, jump- ers should be installed on pin pairs 1-2, 5-6, and 9-10 of the Audio FP header. If these jumpers are not installed, the back panel line out connector will be disabled, and pin 1 of the microphone in will be left floating, which can lead to excessive back panel microphone noise and crosstalk. See the table at right for pin definitions.

CD Header Pin

Definitions (CD1)

Pin# Definition

1Left

2Ground

3Ground

4Right

Front Panel Audio Pin

Definitions (JC2)

Pin# Definition

1MIC_L

2Audio Ground

3MIC_R

4FP Audio Detect

5Line_2_R

6Ground

7FP_Jack Detect

8Key

9Line_2_L

10Ground

5-20

Page 52
Image 52
SUPER MICRO Computer S120T, SERIES3800 user manual CD Header, Front Panel Audio Control