Suunto MARINER | REGATTA | YACHTSMAN manual Stopwatch SUB Mode, How to Use the Stopwatch

2.PRESS the [Select] button and hold in for 2 seconds. Located in Field 1, the “ON” or “OFF” will begin to flash.

3.PRESS either the [+] or the [-] button to toggle between “ON” and “OFF”.

4.At the setting desired, PRESS the [Select] button to move to the next setting. Located in the center of Field 2, the hour will begin to flash.

5.PRESS the [+] button to scroll the hour upward or PRESS the [-] button to scroll the hour downward.

6.At the hour desired, PRESS the [Select] button to move to the next setting. Located on the right of Field 2, the minutes will begin to flash.

7.PRESS the [+] button to scroll the minutes upward or PRESS the [-] button to scroll the minutes downward.

8.At the minutes desired, PRESS the [Mode] button to accept the changes and exit the setup program. A small bell will appear at the bottom left side in Field 2 to signify an alarm has been activated.

The Alarm setup is complete. To activate up to three alarms, please repeat steps 1-8 for the selected alarm (1, 2, or 3).

4.3 STOPWATCH SUB MODE

The Wristop Computer stopwatch sub mode can provide split time measurement and two finish times up to 24 hours. In the TIME mode, PRESS the [Select] button twice to enter this sub mode.

In the Stopwatch sub mode (Fig. 23):

•Field 1 displays the seconds and tenths of a second,

•Field 2 displays the current time, and

•Field 3 displays hours and minutes and to the far right “stopwatch”.

4.3.1 How to Use the Stopwatch

There are three timing modes the user can employ:

•an elapsed time measurement;

•a split time measurement; and

•a two finish time measurement.

20