Symantec Security Expressions Server manual Other Options Settings, Credentials Settings

SecurityExpressions Server User Guide

restart would take.

B. If you want to set a time limit on how long the task can attempt reaudits, type the number of hours you want to allot for reaudits in the Attempt re-audit for this many hours after initial audit box.

A reaudit cycle could go on indefinitely if a system is off or never connects. Setting a time limit keeps the reaudit cycle from continuing indefinitely.

C. If you want to limit the amount of times the task can attempt to reaudit, type the number of reaudit attempts you'll allow in the Maximum number of attempts to re-audit box.

A reaudit cycle could go on indefinitely if a system is off or never connects. Limiting the number of times the task can attempt to reaudit systems keeps the reaudit cycle from continuing indefinitely.

Both steps B and C provide end points to the reaudit cycle. You may use one method or the other, or both. If you use both methods together, whichever limit is reached first ends the audit cycle.

Tip: Steps 11 and 12 each provide a way for audits to occur on systems that were not available when the task was scheduled to audit them. You may use these features together or separately. If you use them together, Audit-on-Connect is active both during and after the reaudit cycle.

If a system was contacted but the login credentials were incorrect, the task does not attempt to reaudit the system.

Other Options Settings

13.If you want to limit the length of time this task takes to complete from the time it actually begins auditing, regardless of the reason, click the Limit to Hours radio button in the Maximum amount of time an audit may run section. Then type the number of hours to which you want to limit the task.

After this number of hours, the task finishes auditing the system it was working on and then terminates. If reauditing or Audit-on-Connect on Fail is part of the task, they are included as part of the overall time it takes to run the entire task.

14.If you want to keep track of which target systems the task could not audit, check Enable in the Save target names that could not be contacted to the following machine list section. Then type a name for the machine list, using variables in the name if you want.

The machine list you enter saves the names of all systems that did not get audited as a result of the termination. Auditing this machine list later enables you to finish auditing the

remaining systems.

If you type the name of an existing machine list, any systems already listed in it will be removed. Unless you want the machine list altered in the case of an incomplete audit,

we recommend creating a database machine list expressly for this purpose.

Credentials Settings

70