MIL-BOOK™
OPERATORS MANUAL
- 2-6 -
Figure 2-7 Removing a PCMCIA Cards
2.3.7 Hard Disk Drive Module
To remove and replace the HDD module.
NOTE
Installing or removing a hard disk when the computer is “On” can destroy the system
board and hard disk.
1. Turn the MIL-BOOK 1000 “Off”.
2. Loosen the captive screws securing the access door.
3. Use the handle on the access door to carefully pull the HDD module out and away
from the MIL-BOOK 1000 (See Fig 2-8).
4. Insert the new Hard module into the slot. Gently push the HDD module in, until it
seats firmly in place. Secure the captive screws on the access door. Turn the
power back “On” to the MIL-BOOK 1000.
5. If necessary, run the system configuration utility, to set up or make any changes to
the HDD drive parameters. See Chapter 3 for details.