Tally Genicom T9220 manual Displayed tray is Load the corresponding size

Message	Status	Do this...
		The job will be automatically
		cleared and the printer will
	The printer does not	return to ready mode.
		• Expand the memory in your
MEMORY OVERFLOW	have enough memory
		printer. See“Installing
	to print the current job.
		Memory, Barcode and
		PostScript DIMMs” on
		page F.3.
		Simplify the page layout and
		remove unnecessary graphics
		from your document.
PAGE TOO COMPLEX	Too complicated data	If the message persists,
	was sent to the printer.
		expand the memory in your
		printer. See “Installing Memory,
		Barcode and PostScript DIMMs”
		on page F.3.
PAPER EMPTY	The displayed tray is	Load the corresponding size of
[SIZE]IN[TRAY]	empty.	paper into the tray.
READY	The toner cartridge in	Redistribute the toner, referring
	your printer is nearly
LOW TONER		to page 6.4.
	empty.
SERIAL ERROR
* may be shown only if you	The printer detects a	Set the baud rate the same as
	serial interface error.	the setting on your computer.
installed the optional serial				7
interface card.
		The overflow of the waste toner
		contaminates the inside of the
		machine.
		Regardless of the remaining
		toner, this is warning message
	The life of some parts	showing that The toner cartridge
READY		replacement is needed as the
	on the toner cartridge
REPLACE CART		parts life there of is exhausted. the
	ends
		toner cartridge is at the end of its
		life and the print quality lowers,
		You need to replace
		the cartridge to new one. to con-
		tinue printing, press On-Line/
		Continue each time you print a
		page.
	The firmware	You need to download the
WAIT IMAGE	programme in the	programme to the printer
	printer has been	again. Contact your local Tally
	damaged.	dealer.
		SOLVING PROBLEMS	7.21