18
Operating Procedures Model 5454
Note: The scraper blade must fit securely over the pin
to prevent costly damage.
Figure 8
Assemble the front blade on the beater, and slide the
beater assembly into the freezing cylinder.
Figure 9
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be cer tain that
the beater is properly seated. When in position, the
beater will not protrude beyond the f ront of the freezing
cylinder.
Figure 10
Step 3
Assemble the freezer door. Place the freezer door
gasket into the groove on the back of the f reezer door.
Slide the front bearing onto the bearing hub so the
flangededge is agains t the door. DO NOT lubricate the
gasket or bearing.
Figure 11
Slide the two o-rings into the grooves on the prime
plug. Apply anev encoat of lubricant to the o-rings and
shaft.
Figure 12