41
Model 5454 TroubleshootingGuide
PROBLEM PROBABLE CAUSE REMEDY PA GE
REF.
10. There is excessive
mix leakage into the
rear drip tray.
a. The seal on the drive shaft is
either worn or missing.
a. Install the drive shaft seal.
Replace rubber parts every 3
months.
44
b. There is improper lubrication
on the driveshaft.
b. Lubricate the drive shaft
properly.
17
c. The rear shell bearing is worn. c. Call a service technicianto
replace the rear shell bearing.
--
d. The gear box is out of
alignment.
d. Call a service technician to
align the gear box.
--
e. The drive shaft and beater
assembly is working forward.
e. Call a service technician to
correct the problem.
--
11. The drive shaft is
stuck in the gear box
coupling.
a. There is lubrication on the end
of the drive shaft.
a. Do not lubricate the end of the
shaft. Call a service technician
for removal.
--
b. There are rounded corners on
the shaft, gear coupling, or
both.
b. Call a service technician to
replace the gear coupling,
drive shaft or both.
--
12. The freezing cylinder
walls are scored.
a. There are broken pins on the
beater assembly.
a. Repair or replace the beater
assembly. Be sure the scraper
blades are properly seated on
the pins.
--
b. The gear box is out of
alignment.
b. Call a service technician to
align the gear box.
--
c. The beater assembly is bent. c. The beater assembly must be
replaced. Call a service
technician to correct the
cause of the bent beater.
--
d. The front bearing is missing. d. I nstall the front bearing on the
back of the freezer door.
18
13. The spinner shaft will
not rotate to blend the
syrup and mix.
a. The flexible coupling is
broken.
a. Call a service technician to
replace the flexible coupling.
--
b. The pin is missing on the
quick disconnect of the
spinner coupling.
b. Call a service technician to
replace the spinner coupling.
--
c. The spinner motor is out on
thermal overload.
c. Allow the spinner motor to
cool. Check the lubrication on
the spinner shaft. Lubricate
the spinner shaft properly.
20