Teac AG-10DAV owner manual Tuner, FM Mode Button

1 3 2 4

1

2

3

4

72

Tuner

1Select TUNER by turning the FUNCTION knob (or press the TUNER button of the remote control unit).

Make sure the antennas have been connected (see page 6~8).

2Select AM or FM by pressing the BAND button.

<If the BAND button is pressed while the source other than TUNER was selected, the source will be switched to TUNER automatically.

3If "PRESET" indicator is lit, press the TUNING MODE button to select the manual tuning mode.

The "PRESET" indicator disappears from the display. This button is used to change the tuning mode.

<When using the remote control unit, you can skip this step.

4Select the station you want to listen to (auto selection).

Hold down the TUNING/PRESET button (or the TUNING button of the remote control unit) for more than 0.5 seconds.

When a station is tuned in, the tuning process will stop automatically.

If you want to stop the tuning process, press the TUNING/PRESET button.

Selecting stations which cannot be tuned automatically (manual selection)

When the TUNING/PRESET button is pressed momentarily (0.5 second or less), the frequency changes by a fixed step.

FM : 50 kHz steps

AM : 9 kHz steps

Press the TUNING/PRESET button repeatedly until the station you want to listen to is found.

<"TUNED" is displayed when a broadcast is correctly tuned in.

FM MODE Button

Pressing this button alternates between Stereo mode and Mono mode.

Stereo:

FM stereo broadcasts are received in stereo and the "ST" indicator lights in the display.

Mono:

To compensate for weak FM stereo reception, select this mode. Reception will now be forced monaural, reducing unwanted noise.

ENGLISH