Technicolor - Thomson 15LB020S4 Programming the remote control, time by pressing the EXIT button

Operation

Using the remote control for other equipments

The remote control supplied with your set can be used for
other equipment, such as video recorders or DVD players.			Programming the remote control
This page provides information concerning the remote
control’s use with these types of equipment.			Automatic code search
			This method can be used to automatically find the most
	VCR	DVD
			appropriate code for your appliance.
VCR	Press the VCR		1. Switch on the appliance you wish to use the remote
			control with.
	button
			2. Press the relevant button for this appliance on the remote
DVD		Press the DVD	control, and while holding this button down, press the
		button	standby button until the remote control light comes on.
	On/Standby	On/Standby	Release the two buttons.	En
			3. Point the remote control at the appliance and press
MENU	To display the main	To display the main	PLAY. Wait until the light stops flashing. If the appliance
	menu	menu	has not gone into standby mode after five seconds, press the
			PLAY button again to continue the search for the next set of
	Vertical scrolling in	Vertical scrolling in	codes.Repeat this operation until the appliance goes into
	menus	menus	standby mode. There are 20 sets of codes.
	Horizontal scrolling	Horizontal scrolling	4. When the appliance goes into standby mode, press the
			standby button on the right side to switch it on again.
	in menus	in menus
			Then press the REV button to put it back in standby mode,
OK	To confirm an action	To confirm an action	and if necessary, keep pressing until the appliance goes into
			standby.
EXIT	To close a menu	To close a menu	5. Press the STOP button and hold it down until the remote
0-9	To directly access	To enter numeric	control light goes off.
			Note: you can cancel the programming operation at any
	channels or enter	values or select	time by pressing the EXIT button.
	numeric values	options in menus
PR+/PR-	To change channels		Manual programming
AV	To select AV input		This method involves carrying out a manual search for the
			codes to be used for controlling your other appliances.
REV	Rewind	Rewind	1. Switch on the appliance you wish to use the remote
			control with.
PLAY	Play	Play	2. Press the relevant button for this appliance on the remote
			control, and while holding this button down, enter one of
FWD	Fast forward	Fast forward	the codes relevant to your make of appliance (there is a list
			of codes at the end of this manual). If the remote control
STOP	Stop	Stop	light flashes you have entered the wrong code or it is not
			possible to program the remote control.
PAUSE	Pause picture	Pause picture	3. Point the remote control at the appliance and press the
			relevant button (VCR or DVD). Press the	standby button.
REC	Record
			If the appliance does not go into standby mode, try another
			code.

Depending on the year of manufacture and the type of appliance, some functions may not be available.

Certain codes may cover more functions than others. Test the functions you can control and, if appropriate, try other codes.

Note here the code(s) which work best.

When you change the remote control’s batteries, remember to reprogram it.

11