E-DOC-CTC-20061027-0003v2.0
Eth Commands
319
eth switch shaper ifconfig
Configure per port shaper parameters.
SYNTAX:
where:
RELATED COMMANDS:
eth switch shaper ifconfig port = <number{1-4}>
ingress = <disabled|enabled>
shaper = <number{0-1}>
[state = <disabled|enabled>]
[speed = <number{64000-100000000}>]
[burstsize = <number{6-126}>]
port Port number REQUIRED
ingress Enabled: port is ingress port
Disabled: port is egress port
REQUIRED
shaper Shaper instance REQUIRED
state Enable/disable shaping OPTIONAL
speed Speed in bits/sec. OPTIONAL
burstsize Burst size in KBytes OPTIONAL
eth switch shaper config Configure common ingress shaper parameters.
eth switch shaper iflist Display shaper configuration per port.