E-DOC-CTC-20061027-0003v2.0
NAT Commands
576
nat tmpladd
Add an address mapping template.
SYNTAX:
where:
nat tmpladd [intf = <string>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[timeout = <number{0-65535}>]
[type = <{napt | nat}>]
outside_addr = <ip-range>
[inside_addr = <ip-range>]
[access_list = <ip-range>]
[foreign_addr = <ip-range>]
[protocol = <{supported IP protocol} or number>]
[outside_port = <port-range>]
[inside_port = <port-range>]
[mode = <{auto | inbound | outbound}>]
intf The IP interface name. OPTIONAL
group The IP interface group scope for this template.
Choose between:
>wan
>local
>lan
>tunnel
>dmz
>guest.
Note If an interface has been defined with the parameter intf,
then the setting for this parameter is ignored.
OPTIONAL
timeout A number between 0 and 6553 (seconds).
Represents the lifetime for this template.
OPTIONAL
type The type of NAT map to be used.
Choose between:
>napt: The map is a NAPT map or a port-shifting NAT map.
>nat: The map is a basic NAT map or a two-way NAT map.
OPTIONAL