E-DOC-CTC-20061027-0003v2.0
ATM Commands
22
atm ifconfigConfigure an ATM interface.
SYNTAX:
where:
iThe interface to be configured must not be connected at the time of configuration. If this should be
the case, use the command :atm ifdetach before using the command :atm ifconfig.
atm ifconfig intf = <string>
[dest = <string>]
[qos = <string>]
[clp = <{0|1|classification}>]
[clpthresh = <number{0-15}>]
[encaps = <{llc | vcmux}>]
[retry = <number{0-65535}>]
[fcs = <{disabled | enabled | auto}>]
[ulp = <{ip | mac | ppp}>]
intf The name of the ATM interface to be configured. REQUIRED
dest The WAN destination for this ATM interface.
Typically, an ATM phonebook entry.
OPTIONAL
qos The name of the Quality of Service (QoS) book entry to apply on this ATM
interface.
The default is default.
OPTIONAL
clp The mode used to determine the CLP bit value OPTIONAL
clpthresh Priority class threshold where CLP becomes 0 (for all classes >= threshold) OPTIONAL
encaps The type of encapsulation to be used for this ATM interface.
Choose between:
>llc: Logical Link Control (LLC) / Sub Network Access Protocol (SNAP)
>vcmux: Virtual Channel MUltipleXing (VCMUX).
The default is llc.
OPTIONAL
fcs Enable or disable the inclusion of the Ethernet Frame Check Sequence
(FCS) in the packet header on the WAN side (only used for llc
encapsulation for mac).
The default is disabled.
Note This parameter is normally left disabled.
OPTIONAL
retry A number between 0 and 65535.
Represents the number of times the Thomson ST retries to set up a WAN
connection before giving up.
The default is 10.
OPTIONAL