1103907432 DR5060 M1_105x148,5 25/04/14 16:00 Page8
IS THERE A PROBLEM ?
Problems | Possible | Solutions | |
causes | |||
|
| ||
There is no steam. | The steamer is not | Check that your appliance is | |
| plugged in. | correctly plugged in. | |
|
|
| |
| The water level is too | Unplug your appliance and refill it. | |
| low. |
| |
|
|
| |
| The steam button | Press the steam button | |
| has not been primed. | continuously for a few seconds to | |
|
| begin steaming. | |
| You use the | When the appliance is new, press | |
| appliance for the first | the steam button a few times. | |
| time. |
| |
| The water tank is not | Ensure that the water tank snaps | |
| in place. | in when put into place. | |
|
|
| |
The appliance does | It is not plugged in. | Plug in your appliance. | |
not heat. |
|
| |
|
|
| |
Water leaks or spits. | The water tank is not | Be sure that the water tank snaps | |
| in place. | when put into place. | |
|
|
| |
| Your appliance is not | Allow your steam brush to heat | |
| hot enough. | for approximately 30 seconds | |
|
| before using. | |
|
|
| |
| The dual voltage is | Ensure that the dual voltage | |
| not set correctly | selector is in correct voltage | |
|
| position before operating. Unplug | |
|
| the appliance and switch the | |
|
| selector to the correct voltage. | |
|
|
| |
There is not enough | The dual voltage is | Ensure that the dual voltage | |
power or too much. | not set correctly. | selector is in correct voltage | |
|
| position before operating. Unplug | |
|
| the appliance and switch the | |
|
| selector to the correct voltage. | |
|
|
|
For any product problems or queries, please visit our website - www.rowenta.co.uk
or contact our Helpline on 0845 602 1454 - UK (01) 461 0390 - Ireland
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
‹Leave it at a civic waste disposal centre.
8
