MODEL 2230R, Process Hydrogen Analyzer
SAFETY MESSAGES
Your safety and the safety of others is very important. We have provided many important safety messages in this manual. Please read these messages carefully.
A safety message alerts you to potential hazards that could hurt you or others. Each safety message is associated with a safety alert symbol. These symbols are found in the manual and inside the instrument. The definition of these symbols is described below:
IMPORTANT NOTICES
Read and understand this operating manual before installing or using the unit. Only use cables from Model 2230R with this unit. If this equipment is used in a manner not specified by Model 2230R, the protection provided by this equipment may be impaired.
Hydrogen is flammable at 4% in air. Take indications seriously and be prepared to take action. In the event of detection of 4% or higher of a hydrogen gas concentration there is a high probability of a hazard to safety. Inform local emergency response personnel immediately.
LIMITATION OF LIABILITY
In the event of a defect in a product, Model 2230R shall not be responsible for any direct, indirect, incidental or consequential damages resulting therefore, including, but not limited to, loss of revenue and/or profit.
This manual provides information designed to guide you through the installation, calibration and operation of your new analyzer. Please read this manual and keep it available.
Occasionally, some instruments are customized for a particular application or features and/or options added per customer requests. Please check the front of this manual for any additional information in the form of an Addendum which discusses specific information, procedures, cautions and warnings that may be specific to your instrument.
Manuals do get misplaced. Additional manuals can be obtained from Teledyne at the address given in the Appendix. Some of our manuals are available in electronic form via the internet. Please visit our website at:
.
If there are any questions concerning this equipment, please contact your local TAI representative, or the factory directly at:
Page 4
