Tiger Products Co., Ltd 6020009 manual Flail cutter shaft is designed for standard rotation same

(S3PT-7)

(SBM-5)

“Wait a minute...Save a life!”

(S3PT-2)

SAFETY

Be particularly careful when transporting the Implement with the Tractor. Turn curves or go up hills only at a low speed and using a gradual steering angle. Rear WARNING! mounted implements move the center of gravity to the rear and remove weight from the front wheels. Make certain, by adding front ballast, that at least 20% of the tractor’s weight is on the front wheels to prevent rearing up, loss of steering control or Tractor tip-over. Slow down on rough or uneven surfaces to prevent loss of steering control which could result in property damage or possible injury. Do not transport unless 3-Point lift lever is fully raised and in the latched transport position.

Dropping implement in transport can cause serious damage to the tractor and/or Implement and possibly cause the operator or others to be injured or killed.

WARNING!

DANGER!

The rotating parts of this machine continue to rotate even after the Tractor has been turned off. The operator should remain in his seat for 60 seconds after the brake has been set, the PTO disengaged, the tractor turned off, and all evidence of rotation has ceased.

There are obvious and hidden potential hazards in the operation of this Implement as in all power-driven or pulled equipment. REMEMBER! This machine is often operated in rough terrain conditions that include tall grass, weeds, gullies, holes, slopes, hidden obstructions and the like. Serious injury or even death may occur unless care is taken to assure the safety of the operator and bystanders in the area. Do not operate this machine with anyone in the immediate area.

WARNING!	Relieve hydraulic pressure prior to doing any maintenance or repair work
	on the Implement. Place the Implement on the ground or securely
	blocked up, disengage the PTO, and turn off the tractor engine. Push
	and pull the Remote Cylinder lever in and out several times prior to
	starting any maintenance or repair work. (S3PT-9)
DANGER!	This Implement is wider than the Tractor. Be careful when operating
	or transporting this equipment to prevent the Implement from running
	into or striking sign posts, guard rails, concrete abutments or other
	solid objects. Such an impact could cause the Implement and Tractor
	to pivot violently resulting in loss of steering control, serious injury, or
	even death. Never allow the Implement to contact obstacles. (S3PT-12)
DANGER!	The flail cutter shaft is designed for standard rotation (same
	rotation as the tractor wheels during forward travel). Never operate the
	cutter shaft in the reverse rotation. Operating this mower in reverse
	rotation may cause objects to be thrown out the front of the mower
	head.
	Twin rtry Safety Section 1-10