Tiger Products Co., Ltd 6020009 manual Maintenance Daily Maintenance Schedule, Maintenance Section

MAINTENANCE

DAILY MAINTENANCE SCHEDULE

The following services should be performed daily or every 8 hours of service, following the detailed maintenance instructions in the operators manual.

______ Pump Drive Shaft:		If required with drive shaft / coupler check for
	end play and lubricate at zerks.
______	Crankshaft adapter: If equipped with rubber grommets check
		condition, replace if missing or damaged.
______	Pivot points: Inject grease until it appears at ends.
______	Hydraulic fittings: Check for leaks with paper or cardboard. Tighten
		fittings or replace hoses immediately.
______	Knives: Inspect for missing or damaged knives, change (only
	complete sets) as needed.
______	Belts: Check / Tighten / Replace belts as needed.
______	Main Frame / Deck: Unless otherwise specified retorque bolts
		according to torque specifications in this
		section.
______	Hydraulic Fluid Level: Add, if required, per fluid recommendations.
______	Rear Flail Drive, Bearing
	Flange and Shaft Couplers: Grease as instructed in the detailed
	(if applicable)	maintenance section.
______	Cutter Shaft and Ground Roller: Grease as instructed in the detailed
		maintenance section
Service	performed by:_______ Date:____/____/____ Hour

Meter:__________

Maintenance Section

** This page may be copied and used as part of the daily maintenance routine.

Twin Rtry Maintenance Section 4-22