
Managing multiple handsets
8Managing multiple handsets
8.1 Adding a new handset
Only needed when you have deregistered a handset or when you bought a new one.
You can register new handsets on the base if these handsets support the DECT GAP protocol. The base can support a maximum of 5 handsets. If you already have 5 handsets, and you wish to add another one or change one handset, you must first delete a handset, then associate the new handset.
Putting the base into registration mode:
1 Press and hold the paging key on the base for 6 seconds. The base will then emit a beep tone.
The LED on the base will start to blink for 90 seconds. During that time, the base is ready to register a new handset.
Register the new handset:
If your additional handset is a Butler E400
4GHI
5JKL
6MNO
4GHI
5JKL
6MNO
2Enter the menu
3Select “REGISTER” and confirm.
4Select “REG BASE” and confirm.
5Enter the number of the base to be associated with the handset
6Enter the Base PIN code (0000 by default) and confirm.
The handset will start searching for the DECT base. If the handset has located the base, it will display the base identification number.
7Confirm or stop.
If the handset does not locate the base, it will return to the standby mode after a few seconds. Try again by changing the base number and check that you are not in an environment with interference. Move closer to the base.
If your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out how to register the handset. The handset must be GAP compatible.
The icon ‘ ’ and the text "NOT REG" flashes on the display when the handset is not associated with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this number that is displayed on the handset after the name and must be used for internal calls.
DECT GAP Profile only guarantees that basic
16