Toshiba 27HL95 Connecting a VCR and satellite receiver, One signal splitter Four coaxial cables

Chapter 2: Connecting your TV

Connecting a VCR and satellite receiver

From antenna

You will need:

￿one signal splitter

￿four coaxial cables

￿one set of component video cables (if your satellite receiver does not have component video, connect the standard A/V cables only)

￿one pair of standard audio cables

￿three sets of standard A/V cables

¥For better picture performance, if your satellite receiver and VCR have S-video, connect S-video cables (plus the audio cables) instead of the standard video cables. Do not connect both types of video cable to VIDEO 1 at the same time or the picture performance will be unacceptable.

¥If you have a mono VCR, connect L/MONO on the TV (VIDEO 1) to your VCRÕs audio out terminal using the white audio cable only.

Signal splitter	IN
OUT	OUT

	Stereo VCR
VIDEO	AUDIO
L	R	IN from ANT
CH 3	IN
CH 4
	OUT	OUT to TV
L	R
	TV upper back panel
TV lower back		TV side panel
panel

￿To view satellite programs using the component video connections:

Select the ColorStream HD video input source on the TV.*

￿To view satellite programs using the standard video connections or to record satellite programs:

Turn on all three devices. Set the VCR to the appropriate line input (refer to your VCR owner’s manual for details). Select the VIDEO 2 video input source on the TV.*

￿To view the VCR or view and record antenna channels:

Turn ON the VCR. Tune the VCR to the channel you want to watch. Select the VIDEO 1 video input source on the TV.*

_____________

*To select the video input source, press INPUT on the remote control (see page 56). To program the TV remote control to operate other devices, see Chapter 3.

From satellite dish
				AUDIO
	Y	PB	PR	L OUT L
Satellite
IN				R	R
S-VIDEO	COMPONENT VIDEO
				VIDEO
OUT				OUT
Satellite receiver

￿To use the TV Guide On Screen¨ recording features:

1.Connect the G-LINK®cable according to the instructions on page 21.

2.Make sure the VCR is connected to the A/V OUT terminals on the TV (see illustration).

3.Set the VCR to the appropriate line input (refer to your VCR owner’s manual for details), and then turn OFF the VCR.

4.See Chapter 5 for details on setting up the TV Guide On Screen® system.

5.See Chapter 7 for details on using the TV Guide

On Screen® system.

Note: The TV Guide On Screen¨ system does not receive program listings from or for any satellite service.

Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT 2, VIDEO 1, and VIDEO 2 terminals when the appropriate input mode is selected.

The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs, and other materials is prohibited under the Copyright Laws of the United States and other countries, and may subject you to civil and criminal liability.

		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.	15
#01E_012-022_27HL95	15	05.9.12, 15:32
	Black

(E) 27HL95 *Web 213 : 276