8Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 27HL95 *Web 213 : 276
1. Carefully read the important safety, installation,
care, and service information on pages 2–5. Keep
this manual for future reference.
2. Observe the following when choosing a location for the
TV:
•
Place the TV on the floor or a sturdy, level, stable surface that can
support the weight of the unit. Secure the TV to a wall, pillar, or
other immovable structure as described on page 3, item 19.
• Place the TV in a location where light does not reflect on the
screen.
•Place the TV far enough from walls and other objects to allow
proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS N OT COVERE D UNDER THE TOSH IBA
WARRAN TY.
•Read “Installation” on pages 3–4.
•Read “Important notes about your LCD TV” on page 5.
3. Do not plug in any power cords until AFTER you have
connected all cables and devices to your TV.
4. BEFORE connecting cables or devices to the TV, learn
the functions of the TV’s connections and controls (pages 9
and 10).
5. Connect your other electronic device(s) to the TV
(pages 12–22).
6. Connect the G-LINK
®
cable (either one of the enclosed IR
blaster cables) from your VCR and/or Cable box (if applicable) to
the G-LINK
®
terminal so you can use the TV Guide On Screen
®
features (applies to VCRs and cable boxes only). See page 21.
7. Install the batteries in the remote control (page 23).
8. See “Learning about the remote control” (page28) fo r
an overview of the buttons on the remote control.
9. Program the remote control to operate your other
device(s) (pages 24–25).
10. AFTER connecting all cables and devices, plug in the
power cords for your TV and other devices.
“Now Booting...” will be displayed on the screen until the picture
appears or the green LED will blink until the TV goes into
standby mode.
When the TV is in standby mode, press POWER on the TV top
panel or remote control to turn on the TV.
Overview of steps for installing, setting up, and using your new TV

Follow these steps to set up your TV and begin using its many exciting features.

Chapter 1: Introduction

11. See “Menu layout and navigation” for a quick overview
of navigating the TV’s menu system (pages 29–30).
12. See Chapter 5 for details on setting up the TV Guide
On Screen
®
system (if available in your area).
13. See Chapter 7 for details on using the TV Guide
On Screen
®
program guide (if available in your area).
14. Program channels into the TV’s channel memory
(page 36).
15. For details on using the TV’s features, see Chapter 8.
16. For help, refer to the Troubleshooting Guide (Chapter
10).
17. For technical specifications and warranty information,
see Chapter 11.
18. Enjoy your new TV!
If the TV stops responding to the controls on the remote control
or TV top panel and you cannot turn the TV off or on, press and
hold the POWER button for 5 seconds to reset the TV.
Note:
If you sell or transfer this television to a third party, be sure
to reset the PIN code as described on page 76 under the heading,
“If you cannot remember your PIN code.”
#01E_007-008_27HL95 05.9.12, 15:318
Black