Toshiba 55WX800 Choosing a location for your LCD TV, Service, Removing the Pedestal Stand, Damage

41)During normal use, the TV may make occasional snapping or popping sounds. This is normal, especially when the unit is being turned on or off. If these sounds become frequent or continuous, unplug the power cord and contact a Toshiba Authorized Service Center.

42)	WARNING: RISK OF
	SERIOUS PERSONAL
	INJURY OR EQUIPMENT

DAMAGE!

Never strike the screen with a sharp or heavy object.

43)• The LCD screen of this product can be damaged by ultraviolet radiation from the sun. When selecting a location for the television, avoid locations where the screen may be exposed to direct sunlight, such as in front of a window.

•Never touch, press, or place anything on the LCD screen. These actions will damage the LCD screen. If you need to clean the LCD screen, follow the instructions in item 35 on p. 4.

Service

44)

WARNING:

RISK OF ELECTRIC SHOCK!

Never attempt to service the TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Failure to follow this WARNING may result in death or serious injury. Refer all servicing not specified in this manual to a Toshiba Authorized Service Center.

45)If you have the TV serviced:

•Ask the service technician to use only replacement parts specified by the manufacturer.

•Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal Stand:

Observe the following safety precautions:

1)Read and Follow the pedestal assembly instructions included with the pedestal.

CAUTION: Before beginning pedestal assembly, carefully lay the front of the LCD Panel face down on a flat, cushioned surface such as a quilt or blanket. Leave the bottom of the unit protruding over the edge of the surface and assemble the pedestal as indicated below.

Note: Extreme care should always be used when attaching the pedestal stand to avoid damage to the LCD panel.

2)Place the TV on a sturdy, level surface that can support the weight of the TV.

3)Be sure to secure the TV to a wall stud, pillar, surface, or other immovable structure. To secure the TV in this manner: (1) attach the provided securement clip to an immovable structure, then (2) pass a sturdy strap

through the securement clip and attach each end to the hooks located on the back of the TV. Be sure to leave at least 4 inches between the TV and the wall or similar structure for ventilation. See item 25, p. 4 for additional details.

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL Listed wall bracket appropriate for the size and weight of the LCD TV (- p. 2) :

CAUTION:

1.Two people are required for installation.

2.Never use the screws attached to the TV.

3.To install a wall-mount from another manufacturer, use the enclosed SPACERS.

1)Unplug and remove any cables and/or other component connectors from the rear of the TV.

2)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket.

3)Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket.

4)Make sure to place the spacers provided with the TV between the bracket and the back of the TV.

5)Always use the screws supplied or recommended by the wall mount manufacturer.

1. Remove the four screws. (Do not use these for attaching a wall bracket.)

2. Place the four spacers (supplied).

Screw

Wall bracket

Spacer (supplied)

TV back panel

Removing the Pedestal Stand

1)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface.

Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the five screws.

3) Once you have removed all five screws holding the pedestal stand in place, remove the pedestal stand from the TV by

Five screws

sliding the pedestal stand away from the TV.

5