Toshiba Pocket PC e800/e805 User’s Guide

Configure Network Authentication Screen

A wireless network can be added either when the network is detected or manually by entering settings information. To determine if authentication Information is needed, see your network administrator.

Select to set WEP (Wired Equivalent

Privacy). Default is Disable.

Select to enable shared authentication

(Shared mode). Default is Disable.

Select if you can obtain WEP key automatically from Access Point. In most cases, default is Enable.

In “Key”, enter the ASCII characters and symbols corresponding to the selected WEP.

Select Key as transmit 1 - 4.

Select to enable 802.1x authentication. Default is Enable.

Select EAP type. Default is TLS (EAP-TLS).

Select to show the Properties when you connect to Access Point with 802.1x authentication.

Data encryption (WEP Enabled) Tap here to enable data encryption.

The Key is provided for me automatically:

Select if you can obtain WEP key automatically from AP. Almost case this function is used with 802.1X function. Default is Enable.

Network Key (WEP key):

Enter the ASCII characters and symbols that correspond to the mode selected.

64 bits (ASCII)

5-digit ASCII characters or symbols can be entered in Network Key.

128 bits (ASCII)

13-digit ASCII characters or symbols can be entered in Network Key.

64 bits (HEX)

Hexadecimal 10-digit English letters and numerals can be entered in Network Key. Letters and numerals that can be entered are 0-9 and A(a) - F(f).

128 bits (HEX)

Hexadecimal 26-digit English letters and numerals can be

114

Page 114
Image 114
Toshiba e800, e805 manual Configure Network Authentication Screen, 114