Toshiba MA-516-100 owner manual Tax 1 % Rate Only, To complete this tax table setting

EO1-11116

MA-516-100 SERIES

2)Tax 1; “A” Break and % Rate Combination (Non-cyclic Breaks + % Rate)

First, set all the non-cyclic breaks up to the “A” Break entry and the [ST] key depression shown in the above case of “1) Tax 1 Full Breaks” .

↓

Tax Rate applied when exceeding the “A” Break amount

(Max. 6 digits up to 99.9999%. Use the [ . ] key for a decimal value. Examples: To set 5%, enter 5. To set 5.26%, enter 5 → [ . ] → 2 → 6. The fraction of the amount resulting from this % rate calculation will be rounded off.)

↓

AT/TL

(to complete this tax table setting)

3)Tax 1; % Rate Only

0

⎯→

ST

TX1/M

(to indicate that no breaks are entered)

Tax Rate applied to any amount ⎯→

AT/TL

(The description for the Tax Rate in the above case 2) is also applied to this case.)

NOTES	1.	For Tax 2 table setting in a multi-tax area, follow the same procedure in 1), 2), or 3) above,
		using the [TX2/M] key instead of [TX1/M].
		To install the [TX2/M] key on the keyboard, refer to Chapter “15. Optional Key Setting” on
		page 30.
	2.	If two tax tables are to be set, the Tax 1 table must be set first. The Tax 1 table setting will
		automatically reset the old Tax 1 and Tax 2 tables. The Tax 2 table can be set only when the
		Tax 1 table has been set (i.e., the Tax 2 table alone cannot be set without setting the Tax
		1 table).
	3.	No second depression of the [ST] key is allowed within one tax table setting. A maximum
		of 64 breaks may be entered for Tax 1 and Tax 2 tables altogether.

- 24 -