Power and Power-Up Modes

Starting the computer by password

If you have already registered a password, there are two ways to start the computer:

Swipe your fingerprint on the sensor if you have already registered the fingerprint with the Fingerprint utility and enabled Fingerprint Power-on Security. If you would not like to swipe your finger or cannot authenticate the fingerprint for some reasons, push the BACK SPACE key to skip the fingerprint authentication screen. You can try to swipe the fingerprint up to five times. If you failed fingerprint authentication more than five times, you must enter the password manually to start the computer.

Enter the password manually.

To enter a password manually, follow these steps:

1.Turn on the power as described in Chapter 3, Getting Started. The following message appears:

Password=

At this point, the hotkeys Fn + F1 to F9 do not work. They will function after you enter the password.

2.Enter the password.

3.Press Enter.

If you enter the password incorrectly three times in a row, the computer shuts off. In this case, you must turn the computer back on to retry password entry.

Power-up modes

The computer has the following power-up modes:

■Boot Mode: Computer shuts down without saving data. Always save your work before you turn the computer off in boot mode.

■Hibernation Mode: Data in memory is saved to the hard disk.

■Sleep Mode: Data is maintained in the computer's main memory.

Refer also to the sections Turning on the power and Turning off the power in Chapter 3, Getting Started.

Hot keys

You can use hot keys Fn + F3 to enter Sleep Mode and Fn + F4 to enter Hibernation Mode. Refer to Chapter 5, The Keyboard for details.

User’s Manual

6-12