Connections (Continued)
Basic TV Connections
Make one of the following connections, depending on the capabilities of your TV.
RF coaxial connection
Connect the RF.OUT jack on the DVD/VCR Receiver to the antenna in jack on the TV using the
Note
If you use this connection, tune the TV to the DVD/VCR Receiver’s RF output channel (CH 3 or 4).
How to set the DVD/VCR Receiver’s RF output chan- nel
When the DVD/VCR Receiver is turned off, press and hold CH/PRESET ( / ) on the front panel for about five seconds to change the RF output channel (CH 03 or CH 04).
Audio/Video connection
1.Connect the DVD/VCR VIDEO OUT jack on the DVD/VCR Receiver to the video in jack on the TV using the supplied video cable (V).
2.Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.
Note
If you use this connection, set the TV’s source selector to VIDEO.
Rear of TV
AUDIO INPUT | VIDEO | COMPONENT/PROGRESSIVE | ANTENNA | ||||
INPUT |
| SCAN VIDEO INPUT | INPUT | INPUT | |||
L | R | L | Pr | Pb | Y |
|
|
A | V | C | R | S |
Rear of DVD/VCR Receiver
Optional TV Connections
Note
DVD playback can also be done using the
V)jack. (See left)
S-Video Connection
1.Connect the
2.Connect the Left and Right AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV using the supplied audio cables (A).
Component Video (ColorStream®) connection
1.Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the DVD/VCR Receiver to the corresponding in jacks on the TV using Y Pb Pr cables (C).
2.Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.
Progressive Scan (ColorStream Pro®) connection
If your television is a
If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD/VCR Receiver.
1.Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the DVD/VCR Receiver to the corresponding in jacks on the TV using Y Pb Pr cable (C).
2.Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.
Notes
Set the Progressive Scan to “On” on the DVD setup menu for progressive signal, see page 21.
Progressive scan does not work with the analog video connections (yellow VIDEO OUT and
12