Toshiba tecra s3 4.7 Wireless LAN card

4.7 Wireless LAN card
Removing the Wireless LAN card
To remove the wireless LAN card, make sure the computer is in boot mode and powered off,
follow the steps below and refer to Figure 4-7.
CAUTION: Do not try to remove the wireless LAN card with the computer turned on.
The computer or the wireless LAN card can be damaged. Do not touch the
connectors on the wireless LAN card on the computer. Debris on the
connectors may cause the wireless LAN card access problems.
1. Remove the following screw securing the wireless LAN card cover.
• M2×4B BIND screw ×1
2. Slide your finger under the wireless LAN card cover and lift it up to remove.
3. Peel off the insulator and disconnect the wireless LAN antenna cables (black and
white) from the wireless LAN card using an antenna coaxial cable disconnector.
4. Press two latches outward to release the wireless LAN card.
5. Disconnect the wireless LAN card from the connector on the system board.
Wireless LAN antenna
cable (white)
Wireless LAN antenna
cable (black)
Wireless LAN card
Latch
Latch
Wireless LAN card cover
M2×4B BIND
Insulator
Figure 4-7 Removing the Wireless LAN card
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-17