2 Troubleshooting Pro c edures
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 2-57
2.13 SD Card Slot Troubleshooting
This section describes how to determine if the computer’s SD card functions are functioning
properly. Perform the steps below starting with Procedure 1 and continuing with the other
procedures as required.
Procedure 1: Check on Windows XP
Procedure 2: Connector Check and Replacement Check
Procedure 1 Check on Windows XP
Insert a SD card into the slot. Check if the installed Windows recognizes automatically the
SD card and the data in the SD card can be read.
If the card is not recognized or data are not read, go to Procedure 2.
Procedure 2 Connector Check and Replacement Check
The SD card is connected to IS2101 on the system board.
Check 1 Make sure the SD card is firmly inserted to the slot (IS2101) on the system board.
If not, insert it firmly. If the SD card is still not functioning properly, perform
Check 2.
Check 2 The SD card may be defective or damaged. Replace it with a new one following
the step in Chapter 4 Replacement Procedu res. If the problem continues, perform
Check 3.
Check 3 The system board may be defective or damaged. Replace it with a new one
following the step in Chapter 4 Replacemen t P rocedures.