Troubleshooting
USB Sleep and Charge function
ProblemProcedure
I cannot use the “USB Sleep and Charge function”.
The setting of “USB Sleep and Charge function” may be [Disabled]. Change the setting to [Enabled] in the HW Setup.
When there is a current overflow of the external device connected to the compatible port, USB bus power (DC5V) supply may be stopped for safety reasons. When this happens, disconnect an external device if some external devices are connected. After that, turn the power of the computer ON/OFF to restore the function. If this function can not be still used even if only one external device is connected, stop using the external device because its current is over the acceptable value of this computer.
Some external devices may not be able to use the “USB Sleep and Charge function”. In this case, please try one or more of the following methods.
■Change a mode setting of [Enabled] by the HW Setup.
■Turn OFF the computer while external devices are connected.
■Connect external devices after turning OFF of the computer.
| If this function can not be still used, change the |
| setting to [Disabled] in the BIOS Setup and stop |
| using this function. |
The battery depletes | When “USB Sleep and Charge function” is set to |
quickly even when I | [Enabled] in the HW Setup, USB bus power |
have turned OFF the | (DC5V) will be supplied to the external device |
power of the computer. | connected to the compatible port. If external |
| device is connected to the compatible port when |
| the AC adaptor is not connected to the computer, |
| the battery of the computer will be depleted even |
| when the power of the computer is turned OFF. |
| Connect the AC adaptor to the computer or |
| change the “USB Sleep and Charge function” |
| setting to [Disabled] in the HW Setup. |
| Instead use a USB port that does not have the |
| USB Sleep and Charge |
| ( ). |
|
|
User’s Manual |
