National restrictions, Country, Restriction | TP-Link TL-WA730RE

National restrictions

National restrictions

This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below:

	Country	Restriction	Reason/remark

	Bulgaria	None	General authorization required for outdoor use and
	Bulgaria	None	public service
			public service

Outdoor use limited to 10

FrancemW e.i.r.p. within the band 2454-2483.5 MHz

Military Radiolocation use. Refarming of the 2.4 GHz band has been ongoing in recent years to allow current relaxed regulation. Full implementation planned 2012

	Italy	None	If used outside of own premises, general authorization is
	Italy	None	required
			required

	Luxembourg	None	General authorization required for network and service
	Luxembourg	None	supply(not for spectrum)
			supply(not for spectrum)

	Norway	Implemented	This subsection does not apply for the geographical area
	Norway	Implemented	within a radius of 20 km from the centre of Ny-Ålesund
			within a radius of 20 km from the centre of Ny-Ålesund

	Russian Federation	None	Only for indoor applications

Note: Please don’t use the product outdoors in France.

Image 4

TP-Link TL-WA730RE manual National restrictions, Country, Restriction, Reason/remark

Contents

TL-WA730RE 150Mbps Wireless Range Extender Rev 1.0.0 COPYRIGHT & TRADEMARKS All rights reserved CE Mark Warning FCC STATEMENTFCC RF Radiation Exposure Statement National restrictions CountryRestriction Reason/remark DECLARATION OF CONFORMITY Product Description 150Mbps Wireless Range ExtenderETSI EN 300 328 V1.7.1 ETSI EN 301 489-1 V1.8.12008& ETSI EN 301 489-17 EN60950-12006 CONTENTS Package ContentsHardware Installation Chapter 3 Quick Installation Guide Appendix B Factory Defaults Appendix C TroubleshootingAppendix D Specifications Appendix A Application Example Package Contents Conventions Overview of This Guide Package ContentsChapter 2 Hardware Installation Chapter3 Quick Installation Guide Introduces how to set your AP to be a DHCP server so 4.6 DHCPthat the AP will automatically assign an IP address for your PC 1.2 Main Features FeaturesChapter 1 Introduction 1.1 Product Overview 1.3 Appearance 1.3.1 The Front PanelTL-WA730RE 150Mbps Wireless Range Extender User Guide LED Explanation 1.3.2 The Rear Panel Ensure the Range Extender is powered on before it restarts completely Chapter 2 Hardware Installation 2.3 Connecting the Device2.1 Before You Begin 2.2 Basic Requirements 1. Connect the Cable or DSL modem to a Router Chapter 3 Quick Installation Guide 3.1 Configure the PC 150Mbps Wireless Range Extender User Guide 1 Select Use the following IP address 3.2 Quick Setup Figure 3-9 Quick Setup Figure 3-12 Quick Setup - Range Extender Mode Figure 3-11 AP List B. When you choose Access Point, take the following steps TL-WA730RE 150Mbps Wireless Range Extender User Guide Chapter 4 Configure the Device 4.1 Status 4.2 Quick Setup 4.3 QSS To add a new device Method One Figure 4-3 Add A New Device Next TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.4 Network 4.5 Wireless 4.5.1 Wireless Settings TL-WA730RE 150Mbps Wireless Range Extender User Guide TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.5.2 Wireless Security 1 Range Extender ¾ WPA-PSK/ WPA2-PSK - Select WPA based on pre-shared key 2 Access Point TL-WA730RE 150Mbps Wireless Range Extender User Guide 4.5.3 Wireless MAC Filtering To set up an entry, follow these instructions To modify or delete an existing entry 4.5.4 Wireless Advanced 4.5.5 Throughput Monitor 4.5.6 Wireless Statistics 4.6 DHCP This page will be refreshed automatically every 5 seconds 4.6.1 DHCP Settings 4.6.2 DHCP Clients List 4.6.3 Address Reservation 4.7 System Tools The changes wont take effect until the device rebootsTo Reserve IP addresses To modify A Reserved IP address 4.7.1 SNMP 4.7.2 Diagnostic Figure 4-23 Diagnostic 4.7.3 Ping Watch Dog 1 Only one user can use this tool at one time 4.7.4 Firmware Upgrade 4.7.6 Backup & Restore 4.7.5 Factory DefaultsTo upgrade the devices firmware, follow these instructions To restore the devices configuration, follow these instructions 4.7.7 Reboot2. Wrong process will lead the device unmanaged 4.7.8 Password 4.7.9 System Log Figure 4-31 System Log Appendix A Application Example 3 Right-click the wireless connection icon “” on the screen of the PC and then select View Available Wireless Networks TL-WA730RE 150Mbps Wireless Range Extender User Guide Appendix B Factory Defaults Default ValueCommon Default Settings Wireless 1. No LEDs are lit on the access point Appendix C Troubleshooting2. The LAN LED is not lit General Appendix D SpecificationsPhysical and Environment Appendix E Glossary TL-WA730RE 150Mbps Wireless Range Extender User Guide