TL-WA830RE 300Mbps Wireless N Range Extender User Guide
¾Run Time - How long this function is running.
¾Transmit - Wireless transmit rate information.
¾Receive - Wireless receive rate information.
Click the Start button to start wireless throughput monitor.
Click the Stop button to stop wireless throughput monitor.
4.5.6 Wireless Statistics
Selecting Wireless > Wireless Statistics will allow you to see the wireless transmission information in the following screen shown in Figure
Figure 4-20 Statistics of the device attached wireless stations
¾Operation Mode - Shows the current operation mode
¾MAC Address - Shows the connected wireless station's MAC address
¾Current Status - The connected wireless station's running status, one of STA-AUTH / STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN / Disconnected
¾Received Packets - packets received by the station
¾Sent Packets - packets sent by the station
You cannot change any of the values on this page. To update this page and to show the current connected wireless stations, click the Refresh button.
If the numbers of connected wireless stations go beyond one page, click the Next button to go to the next page and click the Previous button to return the previous page.
)Note:
This page will be refreshed automatically every 5 seconds.
4.6DHCP
DHCP stands for Dynamic Host Configuration Protocol. The DHCP Server will automatically assign dynamic IP addresses to the computers on the network. This protocol simplifies network management and allows new wireless devices to receive IP addresses automatically without the
36
