TL-WA830RE
300Mbps Wireless N Range Extender User Guide
need to manually assign new IP addresses.
There are three submenus under the DHCP menu (shown as Figure
Figure 4-21 The DHCP menu
4.6.1 DHCP Settings
Selecting DHCP > DHCP Settings will enable you to set up the AP as a DHCP (Dynamic Host Configuration Protocol) server, which provides the TCP/IP configuration for all the PCs that are connected to the system on the LAN. The DHCP Server can be configured on the page (shown as Figure
Figure 4-22 DHCP Settings
¾DHCP Server - Selecting the radio button before Disable/Enable will disable/enable the DHCP server on your AP. The default setting is Disable. If you disable the Server, you must have another DHCP server within your network or else you must manually configure the computer.
¾Start IP Address - This field specifies the first address in the IP Address pool. 192.168.0.100 is the default start IP address.
¾End IP Address - This field specifies the last address in the IP Address pool. 192.168.0.199 is the default end IP address.
¾Address Lease Time - Enter the amount of time for the PC to connect to the AP with its current assigned dynamic IP address. The time is measured in minutes. After the time is up, the PC will be automatically assigned a new dynamic IP address. The range of the time is 1 ~ 2880 minutes. The default value is 120 minutes.
37