TP-Link TL-WA830RE manual Throughput Monitor ¾ Rate The Throughput unit

TL-WA830RE300Mbps Wireless N Range Extender User Guide

¾Beacon Interval - Specifies a value between 20-1000 milliseconds. The beacons are the packets sent by the device to synchronize a wireless network. Beacon Interval value determines the time interval of the beacons. The default value is 100.

¾RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger than the specified RTS Threshold size, the device will send RTS frames to a particular receiving station and negotiate the sending of a data frame. The default value is 2346.

¾Fragmentation Threshold - This value is the maximum size determining whether packets will be fragmented. Setting the Fragmentation Threshold too low may result in poor network performance since excessive packets. 2346 is the default setting and is recommended.

¾DTIM Interval - Determines the interval of the Delivery Traffic Indication Message (DTIM). You can specify the value between 1-255 Beacon Intervals. The default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.

¾Enable WMM - WMM function can guarantee the packets with high- priority messages being transmitted preferentially. It is strongly recommended enabled.

¾Enable Short GI - This function is recommended for it will increase the data capacity by reducing the guard interval time.

¾Enable AP Isolation - Isolates all connected wireless stations so that wireless stations cannot access each other through WLAN.

4.5.5 Throughput Monitor

Selecting Wireless > Throughput Monitor will helps to watch wireless throughput information in the following screen shown in Figure 4-19.

Figure 4-19 Throughput Monitor

¾Rate - The Throughput unit.

35