TP-Link TL-WA830RE manual Diagnostic

TL-WA830RE300Mbps Wireless N Range Extender User Guide

Figure 4-26 SNMP Settings

¾SNMP Agent - Select the radio button before Enable will enable this function if you want to have remote control through SNMPv1/v2 agent with MIB-II. Select the radio button before Disable will disable this function. The default setting is Disable.

¾SysContact - The textual identification of the contact person for this managed node.

¾SysName - An administratively-assigned name for this managed node.

¾SysLocation - The physical location of this node.

)Note:

Specifying one of these values via the Device's Web-Based Utility makes the corresponding object read-only. If there isn't such a config setting, then the write request will succeed (assuming suitable access control settings), but the new value would be forgotten the next time the agent was restarted.

¾Get Community - Enter the community name that allows Read-Only access to the Device's SNMP information. The community name can be considered a group password. The default setting is “public”.

¾Get Source - Get source defines the IP address or subnet for management systems that can read information from this 'get' community device.

¾Set Community - Enter the community name that allows Read/Write access to the Device's SNMP information. The community name can be considered a group password. The default setting is “private”.

¾Set Source - Set source defines the IP address or subnet for management systems that can control this 'set' community device.

)Note:

A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all requests under the corresponding community name.

Click the Save button to save your settings.

4.7.2 Diagnostic

Selecting System Tools > Diagnostic allow you to check the connections of your network components on the screen shown in Figure 4-27.

41