Trane PTAC-SVX01C-EN Installation, Table, Power receptacle configurations, Unit, Voltage, Rating

Installation

Table 3.	Electric heat capacity and electrical data, models PTEE and PTHE(i)
			Nominal heating			Building circuit requirement
	Electric					Unit		Maximum
	heater	# of	Btu/h at	Btu/h at	Total	total	Minimum
Voltage(ii) Size (kW)		stages	230/208V	265V	watts(iii)	amps	ampacity(iv)	protection(v)	Plug
230/208	2.0/1.6	1	6,800/	-	2000/	8.9/7.9	11.4	15	6 - 15 P
			5,500		1600
230/208	3.0/2.4	1	10,200/	-	3000/	13.4/11.8	17	20	6 - 20 P
			8,200		2400
230/208	5.0/4.0	1	17,100/	-	5000/	22.2/19.7	28	30	6 - 30 P
			13,700		4000
265	2.0	1	-	6,800	2000	7.7	9.8	15	7 - 20 P
265	3.0	1	-	10,200	3000	11.6	14.7	15	7 - 20 P
265	5.0	1	-	17,100	5000	19.3	24.4	25	7 - 30 P

(i)All heat pumps have electric heat.

(ii)Minimum voltage on 230/208 volt models is 187 volts; maximum is 253 volts. Minimum voltage on 265 volt models is 239 volts; max- imum is 292 volts.

(iii)Total watts for 7,000 and 9,000 Btu models; add 70 watts for 12,000 and 15,000 Btu models.

(iv)Minimum branch circuit ampacity ratings conform to the National Electric Code. However, local codes should apply.

(v)Overcurrent protection for all units without electric heaters is 15 amps. Overcurrent protection on 265 volt models must be cartridge- style time delay fuses.

Table 4.	Power receptacle configurations
Unit
Voltage		230/	230/	230/
Rating		208	208	208	265	265
Unit plug
Plug amp	15		20	30	15/20	30
rating
NEMA		6-15P	6-20P	6-30P	7-15P/7-20P	7-30P

designation

Receptacle

Receptacle	20	20	30	20	30
amp rating
NEMA	6-20R	6-20R	6-30R	7-20R	7-30R
designation

PTAC-SVX01C-EN 11