Transcend Information TS-ABX31 Standby Mode, Suspend Mode, HDD Power Down, Throttle Duty Cycle

29 BIOS SETUP

•Standby Mode

After the selected period of system inactivity (1 minute to 1 hour), the fixed disk drive and the video shut off while all other devices still operate at full speed.

•Suspend Mode

After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU shut off.

•HDD Power Down

After the selected period of system inactivity (1 to 15 minutes), the hard disk drive powers down while all other devices remain active.

•Throttle Duty Cycle

When the system enters Doze mode, the CPU clock runs only part of the time. You may select the percent of time that the clock runs.

•PCI/VGA Active Monitor

When enabled, any video activity restarts the global timer for Standby Mode.

•Soft-Off by PWR-BTTN

When set to “Instant-off”, the ATX switch can be used as a normal system power off button. When set to “Delay 4 seconds”, you need to hold the ATX switch for more than 4 seconds if you want to power off system.

•Ring Wake Up

This allows either setting of “Enabled” or “Disabled” for powering up the computer when the modem receives a call and the computer is in the soft-off mode.

•LAN Wake Up

This allows you to remotely power up your system through your network by sending a wake up frame or signal.

NOTE: This feature requires the network interface and an ATX power supply with at

least 720mA +5 V standby power.

•Time Wake Up

This item can power on your computer at the time you selected.

•Reload Global Timer Events

When enabled, an event occurring on each device listed below restarts the global timer for Standby mode.